Sounds like you need to adjust the duct latch. You will find it inside the operator side guard. Then remove the cover of the grey box where the...
If you read the thread, the gentleman has tried both long and short grain stock and informs that long is slightly better. If the registration is...
Look at what you are seeing. Your description suggests an obvious indeed problem. Imagine the sheet being bunch up in the middle before printing...
Not an uncommon problem with the LS. Have found that the damp form air cylinder is usually the culprit. You may find it is leaking past the piston...
Because your switch that lifts the guards is all the way to the left which is auto mode. It’s a convenience thing, so by the time you take out the...
Re-read my previous post. To activate unit 4…go up to the unit and raise the inking guard with the switch and leave it in that position. Then...
I’m troubled as to what the problem is because what you are reporting is exactly what the plate changer should do. Is it that you don’t know how...
To stop the plate change process…either press “ready then inch.” Or at either end of the press (feeder and delivery) you will notice a stop...
From memory, try apc on, then ready, then apc on again. This should start the music/process. If this is not correct, then I encourage you to try...
That’s the way it is supposed to work in auto mode. If you are changing all 4 plates simply press the APC and the ready button at the delivery end...
This is not an uncommon problem. So let’s not make an easy job difficult. Firstly, to clean the sensors easily, you should start the press on...
Suggest the easiest way is to adjust the size on the pots rather than getting into the back screens and pressing buttons that may or may not be...
If you have a conventional bearing pull side lay then can I suggest the problem is with off lay timing. Easily check this by feeling the pull...