I would have thought that by changing the motor the potentiometer on the new motor would work, unless it is something to do with the sensor on the...
I don't think so, I swapped them out with keys on the end and the problem follows the key, so now it's at least on the edge and not the middle.
We have a Hamada b452a with the slotted electric ink keys. I assume most ink keys are similar from manufacturer to manufacturer, but I could be...
I did end up finding the problem. There was a breaker that flipped in the side panel gear side of feeder. I believe it was a white switch about...
hello I was wondering if anyone could give me any insight on why the water form rollers glaze over where the color bar boxes are for each unit....
My first set up had the metallic and black switched between the 2 units but I felt like the black was slowly contaminating the gold because after...
I was wondering if anyone knows the trick to printing metallics with DOP plates. We had this problem with our Heidelberg QM's and now when I just...
Hello, I just had a question about what do the knife backing cams do? At the start of changing blades you rotate the cams counter clockwise, but I...
Hello, I've recently stumbled across an issue with the plates in the first unit slipping out of the tail clamp after any type of skew. We're...
I was wondering if anyone knows how to clear out error code 17 from the press. I have to hold in the red stop button to lower/raise feeder table...
Sorry I've been on vacation for the past few days... Yes the cylinder is bad along the blanket and it was worse, I've been wiping it down and it...
Here is the picture, yes it will show up on my sheet and I have to keep an eye out for it and keep my water higher than all the other units, which...
[IMG] This isn't the best picture but this is the tail edge of the blanket, the cyan tones from the tail side and works its way up til it gets...
1.) Max sheet size is 14" x 20". 2.) Our typical sheet size we run is 12.5 x 19, but it does it on different sizes too. 3.) Yes the tone is...
Thanks Tom, that's a good idea, I'll have them add that to the plate. It shouldn't be a blanket issue because I have swapped out the blankets for...
Hello, just got bumped up to the 4 color hamada b452a, and had almost no training on it. We switched from a thicker poly plate (.008) to a...
Hello, our company purchased 2 used PM-46's and they both have the numbering / perforating capabilities and both came with the attachment...