I'm mainly trying to find out what type of coating material to buy and where I can buy it.
Does anyone have experience with this model coater? I have the opportunity to get one but I can't find any info on buying supplies for it, The...
Thanks, I'll check that. A few weeks ago I had this same issue and replaced a different roller. I also tried rubber ink (Van Son) instead of the...
I'm sure I found the problem. A roller in the water system was glazed and I never noticed. I ordered the correct roller and now I wait.
Does anyone have a different "formula", for printing reflex blue? "Formula", could mean a different fountain solution mixture, a different method...
I had something like that happen once, (it was a long time ago so I don't remember the exact details) it was the power switch. The power switch...
Thanks for the suggestion, the first post from printerdan worked out great. I get my film on Wednesday and the guy (Matt) was very helpful and had...
I was seriously considering poly plates just now but I remembered I output positives for screen printers and use negatives for polymer plates....
Thanks for that info. I'm bookmarking that site now. A CTP system is on my list but I want to have one for metal, which is a bit more than a...
Anybody know of a good source for film (in the US) for an Agfa Accuset 1000 plus (#1 Network #135 HN/VLD 14 inch film)? I've been waiting for...
There's a similar thread like this one. You should see it at the bottom of the screen. It's called "No impression trip on 3302". That might give...
Have you bypassed all the sensors on the side panel?
I finally found my parts book. It seems to be a simpler job than I thought. I think I’ll try the proper way of fixing it. Famous last words...
From what I was told, that is the proper way to do it but it requires hours of work in removing the parts to get to the pins, including sensors...
I really wish I could do that but there's a cam in there that opens all the grippers at once and the adjustment for them is minimal at best. I...
Hello, I'm getting nicks in my paper from the delivery grippers on my 3302. It's because of some play in the shaft and I was wondering if anyone...
Have you resolved the issue? This may be obvious but did you pull the latch all the way down? Also have you gotten any prints off this press...
Did you get this issue resolved? What is the condition of the gripper edge of the sheet after printing? A gripper could be opening late.
I'm printing as I'm typing this so I was able to send you a pic. Turn them all off and if it works then try turning one on at a time to see which...
Have you tried bypassing all of the sensors?