You have to take it out of Vario first and then set.
I ran a cd-102 Speedmaser for 17 years, it's a fantastic press. We are now in the process of phasing this press out and replacing with three new KBA.
You're not understanding me correctly
Could also be the type of ink your running.
Make sure your ink charge is set to dump in the plate clamp area.
Yes I would generally agree.
Carton Dimension, XL ?
Start with new blankets, properly set rollers, and minimum minimun minimun, ink, water, pressure.
I hope you have at least two different ink suppliers,and yes it looks like someone is not quite sure of what they're doing.
This happened to me on a CD102 and it wound up being a paddle switch being set to close.[under the floor board gear side] KAB/ Hasbro/Milton/Bradley
To eliminate some possibilities lock off the side guides and ink ducktors and pull a book. KAB/Hasbro/Milton Bradley
Yes metallic ink has challenges
This happened to me a CD102 check for scrape marks on the side paddles, and adjust.
When it comes to trap standard its always first down ink on paper equals your trap standard to be measured from. If gold or silver is not down...
Could always be a thrust bearing check the ductor if its not set correctly it will cause a lot of problems, and try to run a gray field and see if...
MAKE SURE YOUR METALLIC COLOR IS ALWAYS FIRST DOWN AND INCREASE THE VEHICLE IN THE INK BY REDUCING WITH JELL.
It's simply the stop paddle on the top gear side,when you open the floor board.
