Where exactly is this valve? I got no water out of either unit of my washup nozzles. Thanks for you time
Thank you for the advice.
So.... In the end I think it was my water the whole time. I cleaned and adjusted everything from scratch. It got a little better, but changing to...
will do.
Same with me. Used Botcher at my last job. Bought a press and rented a building, wtf. Now that I think about it, I may just fix my water problem....
I have a 2007 SM52. Since setup 3 years ago I have been using Tower Millennium 1000 1 step fountain solution. Agfa set me up with plates and...
I believe you were correct, sir. After pulling and checking and re-setting all rollers the print did get a little more open in the reverse lines....
you are correct. I misspoke. It's not really doubling, more like a halo effect. the second photo is my previous run. It's hard to see, but it's there.
Yes, of course. I did, but most all of the suggestions were related to printing unit to unit. I'm only using one unit. Thanks for the reply,...
I am running an SM52. Running 1 unit, I am getting what I think is doubling. At first look it looks like the ink is contaminated from a drip of...
I think I figured it out. The head suckers were set, with the set screw on the bar, angled a little too far forward (away from the press). This...
I'm not sure what I did different, but the indicator on the feeder panel says the sheet is really early. The panel at the delivery says early. The...
Thank you for the help, but I don't understand how to use this chart. I understand the Spanish words, but not how to apply the numbers to the...
been there!
it is getting better every change I make. I was hoping someone had real world number just to make sure I'm not doing anything crazy. Thanks for...
I am setting my press washup settings for the first time. It does pretty good, but i am not getting completely "free of washup solution" when...
Thank you very much for the offer. My press is being installed tomorrow. I'll keep in touch.
QP equipment California Equipment Movers
As the title says , I need training on a pm52. Need to get up to speed fast. I’ve run all kinds of presses for over 30 years including older...
I’m looking for a Fuji plate supplier in So. Cal.