Just to follow up and let everyone know how we made out. Heidelberg came out and tried replacing the SAP board, but determined that it was the CP...
the 24 and 28 volt both measure correctly. The battery is good and the reset switch didn't seem to help either. We are starting the think that...
Okay, thank you for the diagram. the 5Vdc is reading 5.05 and the 12 volt is reading 12.2
Something just dawned upon us. While the motor was being rebuilt an electric drill was chocked up to the motor end of the worm screw shaft so...
1) On the SAP board, the V6 Red LED is off when the motor is still and turns on when the motor is moving. 1a) The V20 Yellow LED is off until the...
I just measured the gap between the flag and the sensor with a piece of cardstock and it is right between .2 and .3 mm. I also checked the...
Thank you very much for the feedback. The flag to sensor distance is about 1/16" apart. Since the motor brushes were replaced, the motor seems...
We have a '99 Era Polar 66 Cutter that we started having problems with recently. The backgauge started failing to move. We pulled the 24 volt...