Thanks
Here is what I have. Thanks
Do u happen to know the special funtion code to use to manually isert at tail clamp? Thank you
will not take the plate at clamp spring is at 5mm
If u are referring to the cloth motor, what exactly dos it look like on the drive side guard
Appreciate all the feedback . Used the screwdriver test. They both light up. So according to contractor post must be the cloth drive motor. What...
what does the sensor exactly look like? Is it LED? Looked in parts book for it, is it 2?
The cloth starts to advance but then stops after about 10 seconds. Any thoughts to the problem? Tries switching out ones from other units to...
Isint this done at main screen like what I did? Adjusting the gap? Nothing in manual
Yes. But it was so bad had to use a screwdriver
running 17 bins of a thicker book. The book gets stuck in trimmer seems every 10 or so. . Went into accessories at main screen then to trimmer...
Was the clincher a bad jam in it. Had a repairman out. Thanks for help
System a little over a year old. Does not get run daily, and the heads have not been serviced since we got it a little over a year ago. Not...
the right side (non operator) won't staple correctly all the time. Tried adjusting the length. No luck. Any thoughts