Clean it up and use some loctite retaining compound to rescuer it in there, sub 2 minute job, never seen that before ever either, but hay some one...
Bearings - sharft commonly fails on the index wheel, look for lots of red dust, its oftern the cause of reocuring faults there
Bin board connection fault, there in pairs, top one does 1&2 and so on all the way down, probaly got a lose cable - damaged board on bin 3&4's board.
Page 12 in the manual infeed wheels, the 2 springs going up want to be removed from the bit above the blade and clicked into the tops of the...
Its not uncommon, some times if its really bad you have to hit the screw driver with a hammer, like any jam, try softly first then build up the...
Could be down to a few things, you possibly need to adjust the front infeed rollers - belts on the trimmer, if you look in the manual it shows you...
Did they show you how to unjam it by softly tapping the clincher points down with a screw driver? If not they should have done as its a skill you...
Too short - too long and varying is normally down to a wire feed issue, the spring brake bit on the wire spool, they want to be as lose as...
A few, firstly describe won't staple correctly all the time. then we may be able to help. The heads are pretty simple, but the causes and...
Normally simply a build up of dust on the knife position sensors in the back of the machine, 3 sensors on a shaft towards the top of the paper...
The control panel is a std Mitsubishi screen, there available from RS for circa £900, but then you need to pull the programme of the old one and...