I have tried the 425 sprint. The machine requires frequent maintenance if you run thick stock on it. Although it's low on electricity consumption...
Check the limit switches mate. Most of the times these are the culprits. You should also check for faulty relays in the electrical cabinet. If you...
The fun part is the fact we don't have washup devices. :p
Exsctly. We just ran another job and this time we knew why were we filling the table half. Thanks :)
No, not right at all.
Followed the spray powder advice and we completed the job. But never thought of adhesive leaking out. But now I can think why only small feeds...
My bad. I get close to 5mm laterally and barely a range of .1 mm circumferentialy.
True, the bolt was tightened beyond limit. We successfully extracted it. The problem was the bolt was moving freely but the bolt head was not...
Hello everyone, I am having a strange issue in my 1984 Lithrone 40" press. The issue is that the circumference registration only moves very less...
Thanks for the good point
[ATTACH] [ATTACH]
Hi All, We have a broken bolt of the circumferential register assembly. This is one of the four bolts which is used to tight the cylinder. Any...
Can be the ink. Is the problem occuring with other ink in the same unit? Can be the blankets and packings. Make sure the blankets and packing are...
Before tuning the grippers, be sure that they're out of tune at the first place.
clean and lube your grippers.
Was the machine in impression when it stopped suddenly? If you move it by hand, do the following: 1) Trip the main off, i.e. no power goes into...
Good to know. Cheers.
Thanks Chock.
The entire night shift run on gumming sheets (sticker sheets) ended with an output of just 500 sheets. The reason was constant trouble with double...
And do drain your compressor regularly. Else it will be just water and no air.