You have to turn the form rollers on to be able adjust the red screw. It is located under the plate cylinder journal. It moves forward slightly...
QM are have very little room for rubber shrinkage, exactly what you describe the 1st form is the worst. . . If you make the stripe to the transfer...
Each unit will run fine by itself, when running both if you are running too much water it will wash out. Cut back on water. I had this problem...
Yes I have used Lithoperf on a OM 46-2 . good success.
I talked to Stan at Intermountain Press. he talked me through the procedure and up and running.. Huge shout out to Stan for taking the time to...
Working on a QM 456. I had to replace the gears on the feed in roller. Now the press is out of time with the feeder. Anyone know the best method...
Check the cylinder that actuates the impression cylinder. . Most likely small air leak right at the actuator.
I don't know the exact torque setting . Blankets need be tight but not stretched. I start slow and tighten a little at a time. If a blanket is too...
Looks like a roller setting issue. Re stripe ALL rollers, be sure PH is correct , good blanket .. That is not much coverage, when it starts clean...
Blanket cylinder clamps the plate against the plate cylinder during install and rotates three times so plate would be tight but may not be...
I would start checking all rollers settings. Be sure forms are tight and don't have end play. IF they do, pull bearing and add a couple...
Plate Scratches 1st Lesson I learned 40+ years ago. Keep things perfectly clean and take very accurate measurements. I only get Scratches on PU2...
Opps # 3 is from "delivery end"
You can clean blanket three ways. 1 from above, being really careful not scratch plates. 2 from behind, Moved infeed wheels and clean. or #3 my...
IR dyer problems Following
Registration Problem I run a QM everyday. Near perfect registration most papers. To check registration I always put on a side lay mark (when...
