Hi Andy, I went and check the cutter calibration today before proceeding with the re-calibration and found out that it is within the parameter. I...
Hi Andy, Thanks for the quick reply, I'll give it a try and let you know. Vergil
Hi Andy, I saw the TAM board and the appropriate pots with it significant value. There is a black push button switch on the lower front of the TAM...
Hi, We have a Polar Mohr 76 EM, the back gauge position and the display is off by 0.4 inch. I need help on how to calibrate the back gauge to...
Hi, I finally found a replacement PS5 module. I've followed your instruction to leave the rest of the board out and check the 5 volt supply from...
Hi NimeshSilva, I'm looking for the fuse on the PS5 module and can't find it where is it located on the board? Is it a fuseable resistor type...
Hi, I have found out that the 5 Volt module was blowing the fuse. With no schematic diagram I did a hail mary repair, found out that the output...
Hi. I tested the light barrier simulator module on another machine and it is defective. I have already order a replacement module. While trying...
Hi, I found the black light barrier simulator, I tried to re-seat it and cleaned the contacts but I'm still not getting the light to come on. Is...
Hi, I'm not near the machine right now. When you talk about the back panel board is it the Card cage back panel where the cards plug into eg:...
Hi, Normally on power on idle, LED 1,3,4,6,7,12 are ON. if the unit will not cycle LED 1,3,4,6,7 are ON only, missing the 12, it will not cycle...
Hi NimeshSilva It finally quit on me yesterday. This are my observation. 1. The Decimal point was flashing. 2. No error code displayed.(I did not...
Hi NimeshSilva, answer to your questions: While reading your description, I got a feeling that, you have 2 problems. 1. Knife and clamp cannot be...
Hi NimeshSilva, 1. Knife and clamp cannot be operated at all. You press the cut buttons, just nothing,(YES) 2. Knife get stuck during the...
Hi NimeshSilva, The cutter still work intermittently, sometimes will not cycle or will not complete its cycle blade stuck haft way up. I also...
Hi, Needing some help on a Polar Mohr 78 EM, unit will not complete cycle intermittently, stuck with blade down position. I replaced the 4 clutch...
Hi Coloured Paper, You seem to be the go to person for documentation for the above cutters. Will you be able to provide me with that information....
Hi Risu, I'll clean it up again this time I'll get a very fine sandpaper. I was thinking of replacing the relay with a generic general purpose...
Hi Risu, I already removed the plastic cover and tried to clean the contact, it still doing it but not that often. Do you know where I can source...
The complete information for Polar M Standard 92 is model 92 CS. s/n 4911242. If at all possible I like to get further documentation for four...