Also open scorotron and check wire and bobbin.
Try out with new IO and new inks
You could alter recipe with higher trans white so you can go heavier on ink. Dunno just a thought.
Bleh missed the parallel to long side. A better photo would helped faster
Well if not then exchange BID or try a new one. Had a similar problem close to yours and it was BID
PIP and impression drum gears clean and lubricated?
Couldnt you make a hole at foil -meaning trap of white on foil- so white prints on paper?
Merry Xmas to all!
The dial you turn is for impression ONLY. Plate and blanket is FIXED from factory and not to be tampered with! Take the 0.35 mm filler and put it...
You want to measure the bearer rings if they are worn out?
What junker said
Thoughts: 1.Could you change grain? -short to long and vice versa- 2.Magenta dots look ok 3.Exchange order Cyan and Magenta 4.Do you use Super...
There is an option that forces printing on same PIP side for each seperation try that.
You changed both impression cylinder pads or just one? -its a miracle it could print!-
I think you need to change the pads of impression grippers
You are certain that grippers open fully and there is no rust to prevent from opening?
Hello i am working on a GTO 52-2, with the module of Aquatron. If anyone knows if it is similar to Aquaprint
My condolences, sorry for your loss try to be strong
Perhaps if you resent the data of the job? or adjust thickness?
Now i am working on another press but it was a dry waterless press so Vario and hickey picker were non existent. Thank you for your input though