Hi all. I need to find out if one can still get the hydraulic pump for the clamp on a Como maskin, and of so who will be the agents in South...
I see this is a very old post, but I would like to know if your issue has been resolved? I can help you if you need any help on the 1650 XE and 1250.
Issue resolved. Make sure the water temp is between 10 and 14 degrees celcius.
If you are referring to the dripping, I assume that the temp had something to do with it. My theory is: The water was close to freezing and...
Tried it and it worked. The thermostat's numbers is not what it says. I put a digital thermostat in the water and set it according to that. Thanks...
Thanks a lot. Will get a fridge tech to com sort the problem.
Is 3 degrees C to cold for Africa? :-)
What should the temp be in the fridge for the water?
Just did a test print of 200 sheets and it works perfect. 80% screen A2 on magenta with no scumming, water marks or dripping. That's with the 1.5...
I think I have sorted it for now. Metering to Form damper line is now on 1.5 mm and working good. Just gonna do a test print now and see what happens.
5 mm. What is the job of the matt oscillator under the form damper?
It is splashes of water. It happens even with the tap closed and the water on it's lowest level. When the impression goes on the pan roller speeds...
gerhardmmp@gmail.com
Just had a quick read. Is it only for webs or can one get for the MOV and KORD64 as well?
I have a MOV with a Alcolor system and every time the green production button is pressed and the damp units go on impression it looks like a roof...
I'm looking for the change over card for a GTO. (perfecta to straight and back WITH sheet size)