Hello, is the manufacturing year from a Horizon machine in the Serial Nr. indicated? Thank you,
I have following issue on this Wohlenberg cutter: When I operate the two push buttons to intialise the cut cycle - The hydraulic clamp goes down...
We have the Problem that the backlight from the TFT screen is defect. There is an small inverter card beside the screen where we saw that the blue...
Hello everybody, i'm searching for the wiring diagram for a Polar 72 CS, Mach. Nr. 5451197 to fix a problem on this machine. The cut cycle will...
Hi Sir, thanks for your reply and your explanations. In the meantime i noticed following status of the machine. First i thought i have a problem...
Hello Everybody, i have a problem with a Polar 72CS standard cutting machine, Nr. 5451197. I can't release the cut cycle while pushing the 2 cut...
Dear all, does anybody have experience with the Error Code 810 'backgauge motor overheated' on the Polar E Series. The machine is working half a...
I have a problem with the correct reference position of a Polar 66. After switching on the machine and reference drive of the backgauge the...
we replaced the AC-In Board. Further we had a fault contact on the SK-15 plug which is responsible for the 2 cutting push buttons. Also we mounted...
Hi Nimesh Silva, we saw that there is a fault on PCB AC-IN, 040174 of the Power supply. There are conductor paths broken and the contacts of the...
Now the problem has another symptom after switchting on the machine. The message 'please release cutting buttons' appears, but they are not...
Dear all, i have following problem on a POLAR 78E. After 3-4 hours of working with the machine in the morning the problem 469 appears that the...
Hi Nimesh Silva, we where lucky with exchanging the Transistors V37,V38,V39 from PI Board. Now the backgauge motor brake is working normally and...
Hi Nimesh Silva, thank you for the explanation. I'll keep you informed about our result when we change the PI card. Kind regards
Hi Nimesh Silva, again thank you for your support. Regarding the voltage from the transfo I wanted to ask you again to get sure. From the...
Hi Nimesh Silva, I'm sorry I gave you a wrong information about the measurement. We measure constantly a value of 7VDC at the brake coil. Behind...
Hi Nimesh Silva, Thank you for your detailed information. I'm in the secondary operation mode. Further we have dismanteld mechnically the brake...
Hi NimeshSilva, thank you for your reply. The backgauge is not moving. As I wrote in my description it is not possible for me to make the...
We have already changed the trailing cable of the LMS against a new one
Dear colleagues, I have a problem with our Polar 115 EM Mon, Ser. 6331385 After power on the machine I have the message ,no pulses from the...