Just fixed the same problem on a 1995 6c CD 102 by replacing a bad pilot valve located on the impression piston. There are 2 valves, 1 located at...
2001 6c Speedmaster 102 can't receive CIP 3 info from pre-press. Traced the cable to the press and have a good signal. When the RJ 45 cable is...
Sm102...
What is the procedure to increase wash up speed from 5000iph to 7000iph in the cptronics on a 1996 speedmaster 2c.
Sure thing....I'm hoping the same errors still show. I just got off the phone with the plant and after not doing anything but re- tracing the...
I would say, I'm more of a operator than service engineer but have a good understanding and have been able to troubleshoot over the years fairly...
You may have touched on something here. There was a water sensor error but it cleared although this seems to be a re-occurring problem from time...
This is what I originally thought, but can't find anything loose or unplugged. I'll keep looking.
Yes, all 11 EAK boards are showing up and the press won't move, the LED on the power supply board for the EAK positions is not lit. I moved the...
Have a problem with the EAK power supply connection on a 2001 SM102. The supply board doesn't seem to be the problem since the issue doesn't move...
Mathew, Thanks for the reply, I replaced the hose that runs from the "jug" or circulating container to the 4/2 way valve which was broken and...
Replaced the main supply hose for the chain oiler which was broken and leaking. After powering down press, error clears for oil pressure and runs...
Displaying this error: Not enough measuring light, soiled calibration field? Lamp or glass, optical fibre cable defective? anyone have any...
Feeder air blast not operating when lifting pile to run height, but not every time. Usually, lowering and raising pile again will allow air to...
One thing I would add to the list of procedures would be to "not" use glycol based fountain solution or alcohol sub. Use only a solution...
bdrake, I changed the volltage setting and it cured the problem...Thanks again!
bdrake, Thanks for the info and I'll change the voltage setting...
Having to re-boot CPC 21 after 2 or 3 scans, unit showing "electronical plug-in unit communication error" Any ideas? interface pcb? cable? It also...