You should be able to turn off the automatic feeder timing option and manually time the feeder to the front lays on your cptronic display.
Failure to maintain a consistent water level was always my cue to flush the entire system. I consider an individual feed valve to each water tray...
If you were to look for maximum efficiency on a filter you would need to consider your particular needs. Single shift operation? Two shift?...
How long are your typical runs, and what do you consider acceptable density deviations? If your press never gets to a steady state condition when...
I would warn that if you have an expectation of these values being accurate right out of the gate you will be disappointed. It's been my...
My guess would be that you may have to cross the river to NJ as an unfavorable biznez climate has pretty much killed the printing industry in the...
I worked in the NYC printing trade for the better part of 30plus years. The industry has died in New York but you may be able to still find a...
Pre dampening settings as mentioned by Raf. When the dampeners first get dropped you should notice that the damp motors run at a higher speed for...
Them 2 prong sensors are not meant to control water level as much as they are as a warning when the level drops down too low. What's most...
There has been a whole bunch of innovations in the printing industry between the Windmill and the dawn of the digital age in printing, and have...
This is the point where you may need to dig into pocket and hire a specialized sort of consultant. As helpful as this forum is when it comes to...
Have you made it a point to position the plate cylinder so that none of the rollers fall into the gap when you drop them?
It all depends on your quality standards. If your company insists that the press operator not begin counting sheets until all color bars across...
Have you tried wiping down the new plates with water on a sponge BEFORE you try rolling them up? If you opt to try that you will need to begin...
I would offer an alternative to your choices that would fall somewhere in the middle regarding cost. A Speedmaster 72 would offer you larger...
As mentioned an air curtain will greatly improve your dampening control when running smaller sheets across the cylinders. I would not consider it...
WOW.... Thats alot of alcohol!!! I do know that on the 102cm Speedmasters most companies that recover rollers will offer different crown...
Have you pulled out your roller and verified that it was ground with a crown? Ive never ran a SM 52 so im not sure if they even came from the...
a true watermark is in the paper as it comes from the mill. If you print over the watermark it just may disappear under the ink depending on the...
As Adi has mentioned, it sounds like the pigment load of your ink is not the same as what you were once using. Think about it for a moment.... Of...