Opinion does not always equal fact. I try not to mistake my opinion for fact.
Sorry for the delay in getting back but I was doing my job (fixing a Komori!) Firstly the pins that Meny (Eli Zamit) talked about do not 'go'....
God there are some rubbish solutions here. So called Komori experts should stick to what they know.
As a Komori engineer with experience of SP I know they are good presses. If you don't know the machine you shouldn't condemn it. Did anyone check...
The solenoid is fixed to the drive side frame, below the swing arm. Lift the table and you should be able to see a gray or black box covering the...
I expect you have had your press fixed by now. I have had a similar noise many times on customers presses. The latch for the swing arm grippers...
Yes. That's a nasty job. 3 weeks ago a customer of mine did this and I had to strip the keys, blocks, motors and the circuit boards out to clean....
Hi. When you say that the gears appear to be forward this may be normal. When I service a duct I leave a 6mm gap between the gear and the block....
Hi, I have seen similar problems to this. You need to work out if it's the key, the block that moves the key, the motor/gearbox/pot, circuit board...
Hi guys, I have a customer interested in a 4 year old 5 colour 66. Are they a good reliable press? What spares would he need to hold? What are...
Hi Colin, probably best to get an engineer in, if you get time remove the cover where the faulty vernier is and have a look for metal cuttings in...
Hi, did you manage to get to the bottom of this problem? Ray
Hi all, I am searching for a 1 or 2 year old Komori LS 540 + coater for a customer. The press must be in very good condition with no cylinder...
Hi, Dont know if its any help at this stage but the dials are held in place by a tiny grub screw, loosen this to remove the dial. Also worth...
Hi Bennie, I see you are in South Africa, lovely place, once installed an 8 colour Komori there and had a great time. Being Irish I fully...
Hi bet you are looking forward to getting on to your new machine:) You can expect a very similar 'feel' to your old machine, you will recognise...
Hi, Have you recently had the grippers reset, the swing arm grippers are very important to how the sheet is printed? Swing arm problems can...
Hay guys, this is my first post, I worked all over the place as an engineer for Komori UK for about 8 years and have been working freelance for 4...