Far more IMPORTANT than the value of the Inductor, is WHY it failed. NO point in putting in a new one, of it is just going to burn up again....
Designation looks like L1, so it is an Inductor. Probably part of a LC filter on the input supply. For it to have burnt up like that, there...
Wohlenberg now have a LCD replacement as well, but the price is a joke. Part #: WOH-5107777 $6358 each !!!! (excluding shipping !)
Also, check the Clutch Suppressor ( The device wired across the clutch coil) A defective or intermittent suppressor will alter the time it takes...
The mechanical CAM Switches on all Wohlenberg Cutters, eventually give operational issue, because they basically "wear out", As Chock advises,...
Most likely cause: Defective Siemens COUNTER Chip . Plug in IC, easily changed, not so easily found for sale,
There is a reason why users do not normally have the Passwords to alter parameters they do not understand. #1 DO Not alter anything .. keep...
The Counter chip is on the CPU, and just because it is counting, does not mean that it's logic of comparing the current position, with data...
SYMPTOM: On switch on, the back-gauge can move both Forwards and Backwards, until it References. Thereafter, it can...
Brake is ON when the power is OFF. Correct - brake does not have power, so by default, it is spring loaded on, as there is no Brake Solenoid...
You have power to the CPU because the display has a blinking cursor, and there was a beep (That is a good start !!) What Green Leds on the CPU...
Mostly correct, BUT, that advise is for a Systems 85. From the picture sent by the person having the issues, they have a Systems 86/90, so all...
You have a Systems 86/90 machine, and it requires the CPU to be running, in order to start. Your CPU is not starting up, as indicated by the...
So, what did you need to do to make the Backguage more both forwards & backwards after it referenced. ? Your reply may well help others with the...
Have you got your issue resolved ? There is a very high probability that you have a hardware fault on your CPU. Incorrect machine data would...
To enter (check) the Machine Data. Press P key (Program.) While holding in service button, press CLEAR key Then (without service key depressed)...
(1) You have a Systems 90 (2) You have a hardware fault on your CPU board. (not to mention something odd going on with your battery connection.....
When you replaced the battery, you lost all the data in the Battery backed-up ram. This includes the machine data, that is probably now corrupt....
100% agree. Also, many of the older Wohlenberg (S85, 86, 90) have adjustable Taps on their input transformer(s) to adjust and raw, unregulated...
I see a lot of Miss-Information in this post, and no real solutions provided. So. #1 Do NOT replace the Re-Chargeable Nicad Battery (or updated...