iGen3 recently starting having huge blue toner spitting issues which has now progressed into blue background casting. Any ideas why? Haven't...
Igen3. The last few times I've gone to scrub my external heat rollers I've noticed they're absolutely filthy and that the fuser web is completely...
Had this problem before when they were crappy yellow rollers. Replaced them with the black rollers were are supposed to be better, but started...
Leads to this. Any ideas why? Already found a snapped set of screws on the external roll nips and replaced them. Still piss poor adhesion.[IMG]
Paper keeps jamming in the duplex right before it comes back up to the horizontal path to get printed on again. No idea the cause. Happens with...
Never had this problem before, suddenly my paper stock can't get past the stripper feet in the fusing station. No idea the cause. Paper keeps...
Stacker started folding the corners of product before stacking, causing all stacks to be jagged. Even jams sometimes when paper doesn't get make...
Run starts out with all colors fine, then as it progresses the magenta slowly lightens up to the point where it disappears. I don't know how to...
Doesn't seem to matter which side I put up or down, it all fails in the stacker. It's 12 PT, one side gloss, so around 130#. 19x13.
Almost like a deletion streak. It's a disruption in all 4 colors on the outboard edge with a very feint black streak in the middle. Any idea as...
Any idea the cause? Happens on just about every coated stock. More so on the bigger stocks.
And the controller was the main course. I set it up and pressed run and it said, "please wait". Then I smelled burning electrical components....
Title says it all. My finisher has been dropping out of connection on the press, causing a fault that forces me to restart. Sometimes when I...
Not sure if this is a network issue or a Solaris issue, but the other week my Freeflow Server stopped being able to view the windows file share we...
Any suggestions on magnet stock that works? I don't have access to Xerox magnet stock. I tried Nekoosa, but it only runs for one sheet, then it...
So the foam on the ETAC/MOB shield had a huge gap in it. I did not have a replacement, but I made something up with some insulation foam and...
Wondering if some the issues I've been dealing with fuser wise could stem from the paper we're using. Right now we're using New Page Blazer...
I get these whenever I try to run DC0951 after the press having faulted out from an XPE 09 3503. I've cleaned the sensors have a billion times....
This is driving me nuts. The iGen3 was working perfectly for 200 copies, then it decided to adjust image quality. Then it was spitting yellow....
Whenever I print on uncoated stocks, I seem to get this snow like effect on the image on just one side of the paper, like the toner did not quite...