Polar Infrared light guard carry’s out a test on power up, if correct D1/4 and D5/6 will show intensity and alignment. D5/6 only shows test...
I was working on a cp2 and kc2 yesterday evening.. I have access to a test rigs to try various panels , cps software and displays. Always looking...
Well done
We make our own replacement update. Also one advantage relays can be replaced in the future.
[ATTACH]
If knife stopping in different places, check cam switch continuity but also along the cable is a silver box Mhs, the erni relays fail. one of the...
Remove the flywheel cover and clean brass slip rings with some fine wet and dry paper, turning by hand also check condition of carbon brushes,...
So from my understanding the clamp operate and is touching the table and looks correct when using the foot pedal but when the cutting buttons are...
240 error is the program memory needs either clearing or I have had it needing a prog step entering in too. The fault I had on one the other day,...
Setting 1 is fine it’s the shortest delay time Does the clamp move with the foot pedal? early post did you removed the flywheel cover and...
Parameter one and two are to do with clamp and knife delay timing , set both around about two / three. what are they set at the moment?
Look for the knife and clamp logo Machine parameters
When 1st powered on does the clamp move down and return when only using the foot pedal? Also Check for excess preclamping time adjusted in the...
On the keyboard you have light grey and dark grey push buttons. We go for the dark grey group on the left. To initialise the actual memory bank...
I would think it’s more likely it’s hitting the removable soft Plate under the clamp probably been hit by the backguage and pushed the pins...
Remove upper cover on rear of machine 4 screws and lift up sliding it passed the clear rear table cover. On rear of knife beam is a small hex...
I’ve updated to lcd
We supply replacement led screens for polar and Wohlenberg here in the UK Repro-link.com