Hi What is model number of the machine? It might sound funny but what are your stock settings on the machine? I have had a few fiery's where if...
Well they will. It will require a firmware update once connected to the V80. He porbably says that to sell you a new one. Happy Printing
Yes You either need to replace your Black developer and tank or under the black developer tank is a black plastic plate either remove the plate...
Hi Try this. Tell stock manager that the stock is gloss. This will run the fans in the HCF and may help "blowing" any dust off the sheets before...
The fuser needs a rebuild. There is uneven pressure between the fuser belt assy and the pressure roller. Will only effect certain stock...
The trick is to remove the 2 x top screws above the toner bottle (on the machines top lid) This will allow you to leave the toner sitting in the...
Hi Remove the cover on top of the 3 X-Rollers and if you have felt cleaning pads still on the rollers, remove the pads and through them in your...
Hi Your problem is one of several possible things. 1 the CMYK break down of this affected area is above the recommended figure of 240 (add up the...
Hi Measure the distant between those marks on the magenta lines. Were they new drums you fitted?
Hi The recommended life for a 700i I think is around 6 million so at 7.5 million i would run away, unless they give it too you for free.
Hi When flipping the printed sheet over and loading into tray 5 flip length ways not short edge ways. In your artwork print it upside down to suit...
If that fails swag the yellow and magenta drums over see if it changes if not its the drum drive motor.
Ok Hold down 0 and count to 10 whilst holding down 0 press start. you will be prompted to enter the password it is 6789. the setup button on the...
Hi You can try putting electrical tape on the right hand side of the developer tanks where the lid meets the base. this stops the toner leaking...
Ok try this then. If it is a PDF that you are printing it has an option to create booklet. Use that and send the job already imposed and tell the...
Hi I know it sounds funny. try either booting up with the front door open or remove any options you have like finisher or HCF and boot up. hope...
Hi try these NVM changes 763-293 set to 25 (D4 Max Booklet Stapling 2)  763-573 set to 25 (D4 Booklet Staple Sheet Volume Limitation) Hope...
Hi The biggest reason why colour could be off could be just simply dirty mirror (under the glass). Turn OFF the power before removing the glass....
Hi Its the 2nd BTR probably the white wire on the rear of the 2nd BTR. Its either not connected or has a break in it. I hope this helps.
Hi One thing you can try is instead of using 80gsm paper try 120 gsm and telling the 700 that it is even unto 150. you want to get as much heat in...