Looking to sell my Bizhub. Anyone know a company that resells copiers?
In the service manual I found this for Bands, Streaks, Spots, and Smears that appear on the image at a regular pitch. Repetition Spacing (mm) - 4...
Had a transfer belt put in by a technician Friday. Now I am getting small dots repeating every 1.75". On an 11 x 17 sheet the dots are at 7.25"...
Fixed! The clutch was slipping.
The gears all seem to be moving together. One of the top ones is moving a little slower though.
I took the panel off and watched as it jammed. There are a 6 gears there. Can't really tell if it's the gears. Any suggestions?
There is a clicking sound then maybe a little grinding.
I had a Xerox technician in to fix a jam on my finisher. He can't figure out what the problem is. It's jamming in the first section of the...
The codes mean: Tray 5 Lift failure / Lift down failure. I had this problem and replaced the gear on the lift motor. The part # is 655N00367. Hope...
My touch screen is off by about an inch. I followed the procedures to recalibrate it and when I use the stylus to touch the points I hear a beep...
You're welcome. You can buy the part from ComDoc 800-321-4846. Ask for Mike or Debbie. Good luck.
I replaced the sensor under the fuser. The part number is 130K87880.
It sounds like a sensor. Are you sure the fault code isn't 077-219? 077-129 RAP Paper from Duplex did not turn on the Regi Sensor within the...
Black is printing very light. All other colors are solid. I replaced the black developer unit and developer about 100,000 copies ago. It started...
The black specs are back. I change the black developer unit and black developer in January which solved the problem then. I have tried everything...
I detached the finisher and it still won't duplex. Any other ideas? Attached photos show where the paper stops, the red circle is where the broken...
Is the lever on the inside of the finisher door?
Yes, just one sided. It's stopping about 6 inches on the side door slot.
No, I've never detached the finisher.
I disconnected the finisher cable, reconnected it and restarted. Same problem.