The Ryobimatic water system is not everybody's favorite I know, but I have learned to use it and get good results, except for one problem. The...
It has been a long time since I first posted my problems with this press. After reading everyone's post, I have to say they are right on, but...
Could someone please tell the best ink and fountain solution to use on a cold set web press? We are running a Hantscho single color web with a...
Yes we did. We replaced the grippers and stop fingers on the first infeed cylinder. The rubber was all gone from the grippers and there were small...
Today as I set the press, getting it in registration and balancing out the ink, I did not have trouble with a double image until I started...
Thank you for your reply. When you say replace the rollers regularly, what exactly does that mean? For instance, we do not run the press every...
From all I can gather, the Ryobimatic water system is a pain for almost anyone. I have struggled with it for over a year now. I am also told that...
Our shop recently purchased a Screen Platerite 8100. It uses ultraviolet I believe to make processless plates. I understand that technically the...
Is there a no process plate that can be used with film? We would like to go to a CTP, but cannot at this time. If I could use a no process plate...
Thanks for the info, I will look into it.
Can anyone please tell me where the starter for the delivery lamp is located? I have replaced the lamp to no avail, and I know there should be a...
Thanks for your input. Actually, I have made a lot of progress with this press. Of all the problems I have had, the most frustrating has been the...
Thanks again for everybody's input. I have begun to get a handle on it. As far as the water drips, I think I have traced them all done. It is easy...
Thanks for the input. Actually I seem to have solved the yellow ink problem with fountain chemistry, running about 15% alcohol. I am, however,...
So we recently purchased a used Ryobi 3304H with PCS-F. Several of you have helped with other problems. I feel like I am on the verge of making...
Someone else came and found circuit breaker that I had overlooked. A simple push of the button and it was fixed. At least now I know how some of...
I checked the voltages at the small posts on the circuit board for each unit. They are within specs. I removed the motor and plugged it into the...
There is only one water control board, but I did try swapping the plugs from motor 2 and motor 3. The result was the same, motor 2 will not turn,...
Last Friday while cleaning the water rollers a rag got sucked up between the rollers and jammed the water roller motor. We turned the press off as...
Are you saying that if I use the Avantra all I have to do is run the material through the image setter and not the processor? Even if that is...