ill bet there is already a post on this but i cant find it. i get an air bubble under the pip on long runs. is this due to lack of IO under the...
wondering how to adjust the image skew. it is off about 1mm. i saw the adjustment in a wizard, but i dont know where the locking screws are....
is the vcorn board on the 7000 in the press computer, or in the DFE ?
7000 will no longer accept any consumable numbers, scanned or typed in. Anybody run into this ? It says number is not valid and cannot be...
Hey all, where is HP currently holding 7xxx operator training ? It was in GA, then in NJ, as i understand. Is it third party folks doing it, or...
Hi all, I am wondering what kind of nightmare i am looking at to remove a form roller hanger from a GTO-52. The pins that hold the roller bearing...
Hey all, Is the 7000 intended to run short grain text weight paper ? I am getting wrinkles the long way on the sheet in the center. Long grain...
Getting this error code, and software wont load. Only power lights on the BDUs and DIC. I tried a different cable from the MCD (?) and it made...
Having an issue with the ink foaming and overflowing all over the cabinet. I have cleaned the pump, the tank, and the surrounding area. I didn't...
Our 3050 is not printing reversed type clean. It is fine if the reverse is out of a screen, but if its a solid, the type is dirty. It gets worse...
Hey again. Im wondering if anyone else has had issues with air bubbles under the blanket after install. I have the press on impression, and i...
Hey all, I don't have access to a conductivity meter, and I am wondering if anyone has tried this : I have been told that, starting with...
Does anyone know how to release the developer drum slider so I can clean and change the blades ? I have removed the screw that I thought holds it...
Im wondering if anyone has tried Lithoperf on the PM 46-2 ? I dont know if there is enough clearance to allow for the perf strip. Thanks
I am having problems in the delivery with the tail of the sheet not dropping, and the next sheet running into it. This folds the sheet over in...
Looking at iGen 4 or 5 (150). Both used, 5 less so. What is the learning curve from an older digital press ? Brand withheld. I know some love...
Has anyone replaced the belts in the duplexer ? How long did it take, and how difficult ? Thanks.
I am about to start running a black only job, 32,000 sheets, only type. Is there anything i should do with the other 3 colors ? Press is a 3050....
hey all. Just wondering what the effects might be if neither of my scorotron fans are working. I know they don't work, they aren't even in the...
Hey all, Can anyone give me the correct pip bearing part number for a 3050? My parts book gives the M numbers for all the parts, not the CA...