Increase the suction on suction belt. Good idea to "de-glaze" belt also....whilst at idling speed, feeder on, wipe belt with alcohol soaked rag....
Also double check intermediate (Z-roller) setting to Damper form and first form roller. Ters.
Please report back on progress? Ters.
Not trying to cause you or the machine any damage....hence my reply to turn up in small increments. Could only be located on a dry/corroded point?...
Turn the overload dial up.... Do not turn all the way, but small increments. Ters.
Unknowingly Masunda works at a customer of Heidelberg ZA. We visited them last week, and glad to report issue with Perfector is sorted. Segment...
Please explain what you want to reset? Which company in Zim are you from? Dave Gordon is the Heidelberg agent in Harare/Zimbabwe. You can get his...
Rossio, you clown! You have static in your paper pile, or paper was sheeted badly at the mill. Aerate the pile properly, front to back and left to...
Yes Rossio, I am an Instructor in South Africa. I started in the trade working on KORD, (in 1990) and later did my trade test on it. Thank you for...
Massy, is your machine single or multicolor? Ters.
It seems as if all electrical possibilities have been eliminated. Mechanical it could be that your duct is set to hard to your ink-fountain roller...
CP Tronic? Ters.
I am not sure about the print direction of your second image. On your first: re-impo with gutter at the back (turn image 180deg. on plate). Impo...
The spindle on that zone is dirty/sticky. If the problem persists after you followed exheidmech's advice, have it looked at. Ters.
+1 ! Ters.
Hallo Louis. Are you running on gauges or straight? Also check your grip pads, paper pulling out of gripper bar? Sterkte! (Also from SA!!) Ters.
On your feeder board, on the Infeed Gripper bar, there are two small plates that can be swayed down. These are right inline with your Feeder board...
I used a normal ink reducer, with the same results on solids, and less hickies. Ters.
It looks like a Holographic Laminate. Ters.
Exheidmech has valid concerns, please elaborate on what was done to the Pincer bar. Exhdmech, you are correct with the location of the...