Right in that case the Indesign route using the "Print Booklet" feature is the way to go imposition wise. Once thats created just make sure that...
Hi, Are you using Command Workstation with your Fiery? If so there is an "Impose" feature that lets you create an imposed file set up in...
Xerox sell pre cut business card stock so that you just push them out when printed. I'd imagine thats fairly expensive though!
I would just keep putting calls out until fixed its clearly not right. Plus the fact its all Xerox stock too!
We had a few issues with backing up when we first had it but found a good sweet spot when switching between SRA3 and an XL sheet. Never had any...
Been there done that and got the t-shirt :)
Are they in the process direction, perfectly straight and vary in length as well as position? If so your donor rollers on the dev tanks may need...
We had this in a few colours, ended up cutting a bit from a spare transport belt and placing it between the pipe. Works brilliantly!!
Has the film got a white strip along the edge so that the iGen can see the sheet? If it is just transparent then the sensors won't pick anything...
Had the job re-printed with a white boarder around the edge this time. Has been running like a dream all day. Although interesting about what...
The black goes all the way to the edge unfortunately. I'll try cleaning the sensors again in the morning and give it another go. Thanks for the...
Hi there, Struggling with a job at the moment where I am trying to print a code on some pre printed litho sheets. The sheet is black all over...
I've had that problem also in the past and got the wiring altered. I will try and get a good photo of the band next time I see it.
Yep a belt change does the trick. I've tried changing all the bits in the cleaner, giving the ATA a good clean but it still comes back. It looks...
I get this occasionally too, I think it comes on when the machine has been sat doing nothing overnight?
How far out is it? The colour does change slightly each time the iGen cycles down. Also what RIP are you using as we had some trouble with our...
Normally just a restart clears that error?
I had this last week the engineer just replaced the interlock switches on the fuser door and one to the right of the fuser.
You normally get a jam in 2 if you open any of the doors or interrupt it before the green light has gone off when its cycling down.
I have trouble with that too. I process and hold the file edit the curves in image viewer save then submit from the ripped file. I find it to be...