Does anyone know the steps in replacing the feeder joint shaft for a hamada b252 press. Thank you!
My clamp slowly raises up when I change the blade and have the clamp locked with key 1?-Thanks!
This is an ABDICK model, it was the blanket cleaning unit bypass plug on bottom unit. Loose wire was causing press to shut down. I re-soldered the...
problem resolved , this is a abdick model so it has bypass plugs for the blanket cleaning unit. The bottom unit plug wire was loose whiched...
yes
ryobi pfa 3200 shuts off when feeder stops, sensor problem?
yes, Its probably you have a dead battery in your electric panel-I took mine out and got a new one at battery's plus-they even soldered the wires...
Thanks! I'll try that.
Intermittently my sheets bounce, my head stops are all on zero. Is that correct? I always set the side lay according to sheet thickness. Thank...
Does anyone know how to set the front lays, are all numbers supposed to be on zero?
AMETEK part Nr. 119153-51.120 volt , 800 watt -buy it through allied electronics. The brackets fit on the outside of the housing rather than the...
plate unit failure I found the problem, there is a small lithium battery that needs to be replaced every 10 years or so. It is located in the...
When I hang my plates through the auto plate system, the last sequence fails. It initially take the plate in but failure occurs when the tail is...
glazing is just when foreign material builds up on the roller, varnish, toner, etc. I mostly had problems when I folded press sheets that were...
when rollers are glazed up they will slip
Did you try cleaning your rollers with alcohol, I had the same problem, when rollers
i'm not sure what your asking, 73mm would be the distance between staples on a small book and 160mm would be the distance on a large book, for...
Yes, I got one through Ametek in Ohio and it works great, the brackets had to be installed on the outside rather than the inside holes but fit...
Try cleaning the paper dust on the delivery sensor and make sure sensor is lined up with the paper coming out.
Clean all sensors, it sounds like it's going on and off impression, maybe you need to make an adjustment for impression.