Search results

my compressor goes up to about 6 bar and unloads. When the air pressure gets down to about 3 bar it loads again back up to 6 bar. The compressor never stops. It's a KK15 I've disassembled every valve, every switch, took off the heads and inspected, but can't find the issue. Chat gtp says it has...

Where exactly is this valve? I got no water out of either unit of my washup nozzles. Thanks for you time

I have a 2007 SM52. Since setup 3 years ago I have been using Tower Millennium 1000 1 step fountain solution. Agfa set me up with plates and chemistry so I went with their recommendation. I don't really have any problems with what I'm doing, I just think it could be better. I'm running Toyo CE...

I am running an SM52. Running 1 unit, I am getting what I think is doubling. At first look it looks like the ink is contaminated from a drip of washup solvent from the drip tray. I tried running low ink and high water to see if the reverses clean up. Just makes it worse. A preliminary check of...

I'm not sure what I did different, but the indicator on the feeder panel says the sheet is really early. The panel at the delivery says early. The press runs great and register is dead on. I use the knob on the non op feeder panel to adjust and nothing changes. Any ideas?

I am setting my press washup settings for the first time. It does pretty good, but i am not getting completely "free of washup solution" when finished. I've increased the water percentage and time and decreased the roller wash. I'm in California so our roller wash kinda sucks. Can someone share...

As the title says , I need training on a pm52. Need to get up to speed fast. I’ve run all kinds of presses for over 30 years including older Heidelberg’s. I just don’t want to f up my new press. Local to So. Cal. Would be great.

I’m looking for a Fuji plate supplier in So. Cal.

Hi there, I need to move a PM52-2 from Tempe, AZ to Monrovia, CA. Need disassembly, loading, delivery and install... everything. Any advice or recommendations would be very helpful. Thanks

Hi there, I want to start a new company and can't decide on which press to get. The problem I'm struggling with is I don't want to price myself out of shorter runs by going with the sm74. I've run a KORD and a SORMZ, but that was over 20 years ago. i've been in prepress and management since...