Hi. I have had the same problem with knife appearing to stop and start or judder through cutting. It was caused by the safety bolt solenoid...
Hi. Any body got an answer to back gauge not advancing after a cut, it does not advance the cut position on screen either.
Hi. Anybody know how to enable the alphanumeric keypad. We have a second hand one we have obtained and it doesn't work. Our other 115 E does.
Are the three eccentric knife setting screws firmly on the blade. They are located above the knife bolts. They help keep blade from moving
It could be just the back light that is faulty, or inverter. Check if there are 2 white wires to the side of the screen and a little pub, try...
If you buy these boards make sure you check serial numbers are same as yours, there are different versions of these boards and not all are compatable
Hi, I have had similar problems before, worse when machine is cold. Bearings in back end of lead screw sized up, check and replace bearings
Hi. This means when position sensor tripped microcut is not seeing zero pulse from encoder.check LED 22 ON H3 drive see if it lights when rear...
Hi. Does the machine have a rack of I/O boards next to the main board. These will have input( green) leds and red(output) leds.check when you run...
The problem is probably that you have lost the parameters when the battery went flat, email me the machine details size and model and I will email...
I will check error 29 when back in office
If nobody has altered settings on tam card, then tam card or linear rule is faulty, or reference micro switch is faulty
Does the back gauge move forward in automatic mode. If yes the problem is probably on the micro switch located on the hand wheel
Hydraulic oil is 46HV gear oil is 320EP
You can try changing back gauge braking distance. To do this turn machine of while back gauge moving. Then when you switch back on you have to run...
The switches in question are located under the bed at the back of the machine look under the bed near the gear box usually red coloured
Do you know how to insert the machine parameters. If not give your e mail address and I will email how to do this
Hi first does the machine cut in manual, can you use existing programs. If so then maybe memory full
P-err usually means when joystick moved to automatic and programm run button pressed joystick microswitch not seen, probably faulty