You probably have a damaged IDOB module. Open the cover of ink zone push buttons and check if green LED on IDOB module is blinking.
It's a "Auto Zero Calibration" error. It appears after a certain time while AZR cannot perform "auto calibration". You can run calibration...
I agree with Maher. It's a common issue from that age. One blower stops without any warning error in CP2000. Check whether all blowers are...
Can you send a photo?
I'd seen this problem two times before on SM74-4H 1998 and PM74-4 2002. On SM74 the problem was bad connection between AVM and UVM. There is a...
That's right. I appreciate your tips.
Yes, you need to remove allen screw cap and supply tube. The allen screw is stubborn as you mentioned. Use a proper allen key to open it. Do it...
It's not a good idea. Connecting HDD to a PC and run diagnosing program may delete some of WIN files. I did it once with MC7 HDDs and...
I usually push the cylinder to the button and fill it.
It's a common issue with SSK modules. You have replace it. There is a chance to repair it and I can do it for you.
Send me an email if...
There is no oil level indicator for hydraulic pump. If you look from above, behind the block where these 3 sensors are located, you...
You confused hydraulic oil with central lubrication
10 minutes is enough
No, he is wrong. The module marked BLUE is SEK. Take out the one with orange battery on it.
Yes, it is safe. But you need a good desoldering device to take the battery out.
As I told you before, it's better to change the battery...
Did you change the battery? If so, I advise to make reset on SAK.
Check pile height sensor, most probably it is defective.
Just to be in safe side, before you replace the battery, take photo from all "Variant Codes" if table sheet is not available.
Yes, the orange component is the battery.
Yes, it is.
It's hard to find this battery on the market, but you can use an ordinary AA size 3.6V lithium battery with leads instead. There are...