HELLO fellow printers. I am having issues with rollers hanging on one side could bad air cylinder be culprit thanks for the input jack
Lift the spring loaded knurled up with one screwdriver and push pin out with another from behind
Thanks for reply junker not causing any problems yet was in there with the grease gun and noticed it was loose another good reason to use...
HELLO gentlemen how do I tighten the covers on sm 102 year 87 there are 2 17mm bolts on a rail in the middle of the cylinder iwas wondering if...
Look for a small black twist fuse on bottom of the powder unit
What kind of unit did you replace with does it have a sensor make sure it is clean and in the Right position
Have you tried to reseat the boards they sometimes get oxidation on them seat and reseat a few times may help
You should try to unclog the hose may have powder build up work your way down to pump
Hello you have a motor issue check with your technician maybe brushes or brake Good luck
Buy New valves
Hi Bill check the spring on the selinoids there is a long pusher rod that pushes on impression selinoids if spring are wearing you might get...
When you run heavy stock you need to take some pressure off the drive wheels on feed board make sure you are not jamming sheet to head stops...
Clean the eyes might be dirty
It's not an issue
It is telling you that feeder over ride motor adjusmeant is at its forward limit
Clean the chrome with chrome roller cleaner or a soloution of gum Arabic and fountain soloution and pumice powder you should apply plenty of...
20%water 30% wash 350 revolution cycle
Also roller setting is critical if ,y your not touching somewhere in roller train the wash will stay
Hi it is going to be trial and error but your heading in the right direction that low voc wash takes forever ever to dry I would try more water ....
Just wanted to update was able to remove cassette as described by junker many thanks. Jack
