I can't upload your video here. it's big
I use forceps like these. ebay link
The upper half of the holder must still be disassembled. Pay attention to the position of the head motion...
This belt is cut. It is fixed with a plate and a bolt. If you have a suitable tool it can be done without disassembling the whole head.
It will be a long way ... the manual is more than 300 pages.
Do you speak German?
The two things are connected. You can replace the output board from position 10 with that from position 11 or 09, but this will not solve the...
There are many possible problems. Torn belts, poor alignment of sensors, defective engines. Look for a specialist who has repaired the FDM.
It would be the same with 100g/m2. kraft.
If 100g/m2 does not work either, then the problem is in the sensors.
So far (30 years) I have not had...
You have not solved any problem. R700 works normally with 7-800 g/m2 material. I think you need a printer.
AEP->nul.(preset, feeder) and check again. If same, position the feeder at 180 degrees.
You don't need a terminal to check the feeder drives. Тhey are all step.
The process rack has only one button. On 2 slots. It only change the communication mode. It is not a reset.
After using the active mod, the...
Perform the procedure with 01, 02, 03.
I need to see the error message.
Serie 311-314 182 degrees.
Serie 315-326 156 degrees.
Serie 327-330 167 degrees.
Serie 331-> 11 degrees
First check if the SPS loop is closed.
It looks like a corrupted SPS program. Reinstall it.
Try to do an automatic calibration. If it does not work, use CPL service disk. Check which motor is not working. Most likely the motor driver in...
You will have to write more.
If you want the CPL to work well, spray the pad once a week with silicone spray.
Does the plate change normally?
The AC of the 500 is different, but the idea of the main drive is good. 900 has 2 stop commands to drive. Fast and normal ....also the brake is...