As title says. Does anyone know which board causes these problems. Tried rebooting several times. No luck
I’m looking to see if there’s a part number for the bolt only.
How much is oem? Will this chinese made one work?
Does anybody have a part number diagram for the part that broke? Can I buy that separately or is it sold as a whole? TIA
The eccentric does not wanna kick in. Press goes into appointed time/position but press goes around again to find the right position. I do not...
Hi. Is there any other sensor on the perfector apart from these two? It always takes a long time to get my press to go into perfecting. It seems...
Still haven’t figured out where it came from. We’ve been running the press for a week now. No strange noise YET. Everything sounds and works normal.
Issue has been resolved guys. It was the clutch just as I thought.
That’s also what we’re thinking. The bolt was clean when found. No ink or dirt on it when found.
APL. We’ve taken the plate clamps apart several times before and have not seen a bolt like this before.
It’s a Man Roland 700
I’m just afraid to change it over right now yikes
Found it underneath the perfector. I have no clue where it came from. Thanks
Oh gotcha. You mean the gap between the sensors and the plate?
Which one would be the sensor for the pile down button? Bottom light is left side top light is right side.
When I press hard from top of foot, the pile inches up and it starts production normally. Could it be the spring that pulls the presser foot down...
Hi fellows printers. I’m experiencing issues with my Feeder timing. When I start production, the feeder belt slows down big time. And sometimes...