Search results

  1. The name of the article printed on Roland 700 is not displayed

    At least 4 partitions on the disk. Partitioned and formatted in DOS mod on the center console. Then the program must be installed and the orders copied....on D: partition. Can us "saalmaster" disk end "Tools" program.

  2. Roland 300 problem

    You have a missing phase or blown fuse in the main panel. That's says BKF.

  3. Man Roland 300 - Error 90 update

    One of the motors is not working properly. Use of a test program is required. Be very careful. A wrong upgrade renders the system unusable. It is best to contact a specialist who has already worked with CPL

  4. Man Roland 300 - CPL process bus error

    It's not a CPL problem. It's SPS. Write how the error occurs.

  5. 2011 ElTosch Dryer

    Switch to German. The translation is bad. Most likely a CAN problem.

  6. R700 fails when speed 6000sh/h

    Check how this valve works.

  7. R700 problem

    No. Sensor is checked in two positions: activated and passive

  8. R700 problem

    Was err. A353

  9. R700 problem

    Check - A353/7/10.1 A353 board in the 7th place led top right.

  10. R700 problem

    Write which series this machine is. It's so hard to guess. On some machines, the delivery LA8 pump is under the cover after the coating unit inside. There is a problem with the pump stroke sensor (lower sensor). Broken cable, defective input on input board, blocked tubes for LA8. First you need...

  11. R700 problem

    Switch the machine to German and take a picture of the error screen. Don't use Google Translate. Then go with the marker on the message and press "?" button. Take a picture.

  12. R700 problem

    Which of these electrical schemes should I help you with? These are the series up to 2008-10. ... and they are not the same.

  13. Eccentric wrench

    I can send you a few, but you won't like the shipping cost. Make them yourself. I made a sketch for you today. When you understand that this is not the way, I will help you to fix your machine.

  14. R700 problem

    Until you write the SERIES of the machine, you won't get a serious answer.

  15. Eccentric wrench

    Improperly adjusted flaps. Adjust it.

  16. R700 problem

    Capture the error screen. ...I'm sure everyone knows what series the machine is, but I have forgotten...

  17. Eccentric wrench

    I know what it is, but in 30 years of practice I have never used it. You have another problem.

  18. Roland 500: Problem in the firmware of the LENZE

    Did you replace only the drive or together with the communication board? If together, change only the communication board to another PU You can't measure levels on the communication board. There is CAN communication.

  19. Roland 500: Problem in the firmware of the LENZE

    If this lenze is new, it may not be suitable. Take a picture of its serial number.

  20. Roland 500: Problem in the firmware of the LENZE

    Change the communication board. Use a display. It gets easier. Copy paste. ...from another PU ПП Поменяй язик машини, а то по руски не все понимают.
Back
Top