Search results

No oil seal there. Dirt or the return oil channel is clogged. A similar oil leak can also occur if the bronze bushing has dislodged. If so, a major repair may be required.....like this one.

The CCI message can be from any PU. I already wrote. Diagnosis defect. It remains to erase the EEPROMs. For this you need a service diskette. I can sell you a few. ....expensive. ha ha.

You should look in your spare parts book.

Sorry. You have a problem with the blanket cylinder. You just need to disassemble and reassemble. No problem.

I can.

Rodimo does not help for process. The board in the picture is working 100%

The gear should be dismantled, the bearing body removed and the sealing replaced. The gear is on a cone. It can be dismantled only with high pressure oil. (special tool) If there is no one to show you how it should be installed, you have a problem.

One of the error messages is about the feeder timing motor. Call. it's easier.

Normally no light on the step motor board's.

Break the process lup.

Yes. But why all board's shining? Shoot the other PU.

Remove from feeder rack control board of the feder timing, slot 6 and try. ..I am sure you have at least one bad POS controller .

What model is the densitometer? Which lamp did you replace? There are two. Are the two positioning motors working?

New machine installation, or stopped during operation? ....if you write what the machine is, it would be fantastic.

Yes Replace the board from the delivery with a board from a PU. Attention!!! POS should be repaired ONLY when the machine is switched off.

"A" side.

There is no reset button in Roland 300, 500, 700, 900. There is a button that changes the direction of communication. The red (when the cap falls off it turns black) button is for changing the communication: control console - hand terminal. Depending on the software version, it is often...

Possible. .... 10-40%. ..depending on the number of PUs

Yes

Yes. Open the machine configuration and see where the problem is. .....The last error message, "color console not responding", is much more interesting.