Search results

Wrong electrical installation.

These machines disappeared from Europe 10-15 years ago. What is this? Favorite or 600, or 800? It can work without a display. .... if it can work at all. There is no useful information on this display. Call.

Capturе the error messages of the main motor inverter. Check the ink ductor motor inverter on 2 PU

Check the tacho generator and the brake microswitch.

Bad translation. Switch to German, please. So I suspect a foreign body check. Or the hatch under the table, 1PU

Set BIOS correctly. If the HDD is original from Roland, the HDD settings are not standard. Look in the service manual.

CHOCK, there is no 24V transformer in the Roland 700.

Did you check the voltage after them? The same error occurs when one of the powered boards has a bad connection.

You have problems with one of the 24V power supplies in the AX.

Installing MMS SPS is a separate procedure. MMS config alone cannot be installed.

The driver is installed automatically during the console software installation.

You need to copy both directories to the new hard drive after installation. Orders are on disk D:\ Only possible if you install the same version of the program. Use xcopy

The keyboard has no connection to the MMS. It works with it and without it. The green LED in the picture is on the communication board. Token ring. I'm sure you don't have a network set up between the machines. This diode has no connection to the keyboard. The keyboard may not work if: 1 It is...

You have a clogged filter. Check the red buttons on the filters. Side A, In the Diagnosis, Machine menu you can see which PU has the problem. The machine will run for a few days, then stop.

Benny, do you really think the machine has been waiting for you to fix it for a year?

Pozvoni

There are 4 different numbers in time. If you had written down the serial number of the machine, I would have told you the number on the board. Shoot the SPS in the delivery. I'll show you. Where are you from?

Most likely a processor board in delivery.

Call.

Step 3 should be machine configuration. The diskette has the machine number. Not MMS config. As Sergey has shown above