That's the way they die. A loud pop and silence.
Just have xerox replace it. You're on contract right?
It's probably the one that was originally on the right causing the issue. They start getting weak and when you put a lot of power across drone...
You have one of your 36 volt power supplies going bad. The ones with the handles at the back of the output module.
iGen 4? Check the cyan developer drop tube flap in the back of developer housing and see if the plastic arm is broken.
If you like you can give me a call and we can talk to each other directly.714-292-6912
When's the last time you did a color calibration and then a d f e profile? Have you done a d f e profile for each color stock that you run?
I would look at a bad CCD in the registration area.
What's the toner concentration setpoint for yellow and what is it reading?
saying that the airflow in the EU is low flow. It's the tiny door at the area where the hoses go into the back of the marker. Usually the filter...
Yes, I've seen that. There's a DC program that adjusts the prefuser transport speed in relation to the pr belt and fuser.
Give me a call Dennis. This is Milo from Qualitech Digital. 714-292-6912
You should definitely have one near the stacker of it is really a lot of static. Another one around the feeders too.
With the pallet down, check the 1st and 2nd VGT belt holes are all lined up with each other. Make sure the Vacuum blower motors are working...
If you need any support feel free to call. 714-292-6912
There is a diagnostic program you can run to adjust the prefuser transport speed in relation to the pr belt speed.
Cleaning house on Xerox iGen equipment.
2 beautiful condition, running iGen 3s available,
2 feeder mods, 1 stacker 22.5 inch length paper,...
Looks like you need to do some troubleshooting and maintenance if you're getting banding. Is it just in one color?
I usually clean both rollers until they're nice and dark black. That takes care of it 95 % of the time.
I only use 409 because it won't dry out the rubber coating.