Search results

Hi, count from the right, swap the 3rd eak and share a picture of the screen, your errors clearly show the problem is with the EAK13, doesn't matter how many ESK you replace.

Well this has already been discussed, the light either Green or Red should be ON so there is definitely a problem there, on the delivery at the top where the delivery console (buttons) can be opened and that houses the electronics if I am not wrong, the yellow DWBA device and the DIPM you must...

Buckling or bulging of the board as it hits the infeed results in wrong ultrasonic sensor output, make sure you are running the correct air settings on the feeder table, try reducing the suction at the suction tape.

The init and dyn codes of the SSKs are important here. If the light on ssk turns on once at start if means the board is active and is out of the reset state, if the boards work on the other press the problem is most likely as ashok and chock pointed out a 5 volt issue, the 5 volts are coming...

In newer machines we have a board for external input to the main cabinet called the SEM, for your particular machine if I remember correctly there should be a similar board at the back of the main cabinet inside the small box, if you see in the wiring diagram the emergency signals goes through...

The color archive should look something like the attached picture these are reference densities that the axis control is going to follow, pls note you'd we better off hiring an instructor who could train you on the axis control, there are alot of technicalities involved, different surface boards...

Hi, Which color strip are you using currently on the job? Do you have a color control bar on the sheet? Would like to see a picture of the job. Secondly on the screen you shared there is a yello warning sign on the reference value tab on the right, that means you haven't selected a reference...

Hi Chalo, There seems to be no obvious communication related errors, pls share with me the press number, also let me know if this is a combistar CAN, you can share the name plate of technotrans unit. Also when you mean you have no display on the cp2000 screen that means you cannot adjust the...

Press the "?" On the screen, pls share what errors show up

Whenever there is no CAN communication there is always an error, the communication is between the TRE40 (screen) and REK2. There is an error for COM address.

Can you pls send the errors on the unit? Why is there an emergency mode active? Need to know what errors are present.

Hi, In case of no communication with the press there is always an error on TRE40, I need to look it up but may be the battery being dead had changed the configuration to a standalone unit

Have a look at the airstar cabinet nothing to do with F260

Does the error go away and then come back? You need to have a refrigeration expert look at the problem, in case of a water cooled system there is no sufficient external cooling water flow or in case of air cooled system the condensor coil is not being cooled

Check the direction of rotation

The hard drives do not come with the software, your machine comes with a CD for the IPC software which needs to be installed once you get the discs

Hi Alfaro, A brand new hard disc from Heidelberg tends to start up with the windows desktop but you need to leave it alone as it configures itself and restarts, once the configuration is finished you should see a printech or cp2000 logo screen even when there is no software on it. In case a...

No need to swap them around just use the switch to shift to the second hard disk

Hi, have you tried shifting over to the second hard drive?

The grease distribution blocks where the sensors are mounted has a small pin inside that goes in and out due to grease pressure, the pin gets stuck very often and requires a thorough cleaning of the distribution block