Here attached similar to Heidelberg module.
Rules of forum, <*please do not ask for, offer, or share any copyrighted document such as service...
According with the operator manual Heidelberg QM 46 here the details:
The markings of the adjusting screws:
The 1st inking form roller is...
The NTK are o.k.
The problem is
the SBM1+SBM2 power rectifier bridge can be OPEN OR SHORT-CIRCUIT TEST IT. Replace it
1)You must test the time of Feeder in relation to sensors, after you cleaned
2) Tips for Quickly and faster Test for sensor: see it with...
send me your email., perhap i can help you
However test :
a) the springs
b) the solenoids +42Vdc , normally the shaft work in bronze...
Great Sir! good job
Not really, but if you want , you can do it, but more expensive
Roland does not Manufacture the lamp, are other factories that they doing the...
Hi, normally the Stop Button is indicated by factories, and other REGULATORIES building Codes for industrial machine , like IEC, NEC.
You are talking about to installing Lcd vs Crt.
You must understand , that board CP1+VID +EPROM from Polar , must be compatible with the...
I can not understand well, what do you mean when you say:
1) Now i am change this Display
2)Please help me how can i change this...
i told you sir:
1) model exactly
2) serial number
3) part number
4) Watts, and Voltage of lamp.
5) Delivery country for freight
provide me , the tech information.
like model, serial number, and part number, and delivery country
give your email
please test the following:
1) in connector X1 , please test the 3 fuses for to protect the 3 phases Lines: l1+l2+l3 some of them can be...
1) Test the button for dirty, or faulty.
2) tight the wires, or corroded connection in button, repair or replace
3) see for c.breaker +fuses:...
1) Check +42Vdc in plug CU9,2 (Safety Bolt)
2) See basic condition de Led´s V14+V18 both OFF IN BOARD HK, IF ONE IS LIT EXCHANGE HK
Here is the specification for SM 52 and recommendation for Stock
Max sheet 370520 mm
Min. sheet 105145 mm
Max. image area...
Good luck sir
1) Poor encoder z input phase.
When the enconde EN1 z phase is not inputted in the CPU on the base machine motor rotates E-2 will be...
1) Test the power supply for +24Vdc en plug LS 600 CU4
2) Check connections according to wiring diagrams
3) If any Emitter Leds exceed...