Fiery EX560 Shuts Off to Rest if It Receives No Jobs

Discussion in 'Fiery RIPs' started by homeboy, Dec 25, 2022.

  1. homeboy

    homeboy Member

    Joined:
    Jun 2009
    Messages:
    20
    Location:
    Los Angeles
    I have a Xerox Color 550 with EX560 External Fiery.

    When everything is on “on” the system operates normally. However, if no print jobs are sent to the Fiery over TCP/IP for about 10 or 20 minutes both the Fiery and the monitor shut off. The 550 is unaffected and continues to operate as a copier or scanner. You would think that the Fiery has gone into sleep mode and a simple moving of the mouse would wake it up. But the Fiery is completely off and the screen on the Fiery is off.

    If I immediately try to turn Fiery back on, it won’t let me. The on/off switch is inoperable.

    If I try to turn it on maybe an hour or two after it went off, it comes on and gets stuck during start-up.

    If I unplug it and wait several hours before turning it back on, it will boot up and operate normally.

    If I don’t unplug it, the next morning I can turn it on, and it will boot up and operate normally.

    When the Fiery has shut itself off, the monitor is off as well, I assume, because the Fiery is telling it to turn off. For instance, if I turn off the monitor and then turn it right back on, after a few seconds it turns off. But if I disconnect the monitor from the Fiery, the monitor stays on albeit with no signal.

    Are these enough clues to diagnose what’s going on with the Fiery? A service contract on this old machine would cost more than the machine is worth so I’m on my own trying to solve this problem.
     
  2. MWI Print

    MWI Print Member

    Joined:
    Dec 2022
    Messages:
    14
    Location:
    Midwest USA
    Wonder if there are sleep or hibernate options you can change under power options.
     
  3. homeboy

    homeboy Member

    Joined:
    Jun 2009
    Messages:
    20
    Location:
    Los Angeles
    That makes perfect sense, but that's not it. None of those options are enabled.
     
Loading...