"cleanbelt calibration error" xpe-06-3230

Discussion in 'Xerox iGen3, iGen4, & iGen5 Digital Presses' started by peels, Sep 29, 2022.

  1. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    1,113
    Location:
    southeast iowa, usa
    Longshot here, i know this is not the most traveled forum these days...but worth a shot.

    I have an elderly IGEN 4, and I get this error constantly. Nothing seems to fix it forever. Change the belt, its good for a few days. it comes back. Do cleaning things, etacs, mob fixes it. but it returns.

    It passes all color calibration and registration routines but when I go to print. bam! ERROR!

    Milo if you read this, just branching out, tried all the stuff we talked about and some more things too, doesnt seem to matter, feel bad continually asking you.
     
  2. Milo Wilson

    Milo Wilson Senior Member

    Joined:
    Dec 2007
    Messages:
    477
    Location:
    Arkansas
    Don't feel bad. I'll talk to you tomorrow.
     
  3. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    1,113
    Location:
    southeast iowa, usa
    hey @Milo Wilson still havin troubles with this. 06-3230 and 3271 cleanbelt calibration. None of the stuff we discussed works anymore lol Seems to happen most when in a mad rush.

    just thought id put the particulars down here, so I can compile them and have a look later maybe I figure it out.

    If you think of anything else to try, post it :)



    -after periods of non use, the machine will run fine, and continue to run for a while until stopped. then the error shows itself and is difficult to clear.
    -occasionally magenta stuttered streaks on IB and OB edges.
    -new belt and cleaning blade
    -print quality is "OK"
    -just noticed 03-3521 along with it.

    what I do(but think its just luck and time)
    clean etac
    clean lamp(its clean)
    vac cleaning rollers
    it completes 951.
     
Loading...