Wohlenberg 115 year1998

Discussion in 'Cutters and Trimmers' started by Jorge Reis, Oct 29, 2021.

  1. Jorge Reis

    Jorge Reis New Member

    Joined:
    Oct 2021
    Messages:
    4
    Location:
    Portugal
    Hello, I am new to this forum and I need help with my paper cut wohlenberg 115 the lcd is very dark and is getting worst where can I get electrical schematics of the cpu control board and display, for this machine.
    Thank you.
     
  2. Mathew

    Mathew Senior Member

    Joined:
    Apr 2010
    Messages:
    530
    Location:
    Kolding-Denmark
    Hi,
    Send some photos from the LCD panel.
     
  3. Jorge Reis

    Jorge Reis New Member

    Joined:
    Oct 2021
    Messages:
    4
    Location:
    Portugal
    Thanks, here is the foto.
     

    Attached Files:

  4. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Hi Jorge;

    This problem is indicative the thousands of transistor inside from LCD, are faulty, you Will need to replace the LCD Display.

    However, you must Tight very well the ribbon or flat cables, and see if there are o.k, or are Dirty, loose, or broken, or Corroded and clean.

    See if the Display are Battery, and measure the Voltage, and see if there are o.k , otherwise replace with the same characteristic.

     
  5. Mathew

    Mathew Senior Member

    Joined:
    Apr 2010
    Messages:
    530
    Location:
    Kolding-Denmark
    Hi Jorge,
    As Chock explained, the LCD panel should be replaced. I did it on the same control panel one months ago. Send me an email to make a quotation for you. It's better to send it to Denmark for repairing.
     
  6. Jorge Reis

    Jorge Reis New Member

    Joined:
    Oct 2021
    Messages:
    4
    Location:
    Portugal
    Hi Mathew, Thanks for your response, I am sending you my e-mail jorge.reis@bindomatic.com thanks,
     
  7. andy martin

    andy martin Member

    Joined:
    Aug 2016
    Messages:
    96
    Location:
    bradford po
    It could be just the back light that is faulty, or inverter. Check if there are 2 white wires to the side of the screen and a little pub, try changing these
     
  8. andy martin

    andy martin Member

    Joined:
    Aug 2016
    Messages:
    96
    Location:
    bradford po
  9. Jorge Reis

    Jorge Reis New Member

    Joined:
    Oct 2021
    Messages:
    4
    Location:
    Portugal
    Hi Andy, Thanks for the picture I am waiting for the machine to finish the job so I can open the control panel to see what display is and if it looks like the photo.
    I will replay when I open that.
    Thanks.
     

  10. Alonex

    Alonex Senior Member

    Joined:
    Oct 2019
    Messages:
    121
    Location:
    USSR
    Dear Jorge,

    Backlight CCFLamp(s) and/or the CCFL High Voltage inverter(shown on the Andy's picture) should be replaced.

    Regards,
    Oleg T.
     
Loading...