GTO Roller Setting

What is the correct sequence for setting GTO inking rollers?

 

All the information is in your machines' instruction manual.

 

I do not have the instruction manual.

 

Hi, the 1st inking roller (yellow) is 3mm to plate and 3-4 mm to distributor, 2nd one (blue) is the same as the 1st. The 3rd (white) and 4th ( red) is 2mm to plate and 3-4 mm to distributor, don't know if this was the question but hope it help

 

Do you set the rollers to the plate first and then to the oscillator/distributor?

 

First with the distributor and then to the plate

 

Ok. I was told by someone that set to plate then to distributor and then again recheck to the plate. Is this correct?

 

Ok. I was told by someone that, first set to plate then to distributor and then again recheck to the plate. Is this correct?

 

I dont think i'm wrong, first to the distributor and then to the plate

 

3mm to plet and 3mm distributer

 

I dont agree with you Nitin, you should add 1mm more to oscillator or even 0,5 mm. Rollers move from oscillators than plate