heidelberg ft 36 j

Discussion in 'Folders' started by pakerpakiu, Apr 25, 2021.

  1. pakerpakiu

    pakerpakiu New Member

    Joined:
    Apr 2021
    Messages:
    4
    Location:
    malaysia
    Problem that I face is the suction coil for feeder is not functioning because there is no supply from the output board. When I press the feed button, there is response. Relay on board but no output for suction coil. Already sent out board to repair.
     
  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Hi sir;

    What machine is that you have the problem?

    in any case you must measure the secondary of main transformer for Vac, and then test the Fuses, and see the output from Vdc, from the BRIDGE RECTIFIER.!!!
     
  3. pakerpakiu

    pakerpakiu New Member

    Joined:
    Apr 2021
    Messages:
    4
    Location:
    malaysia
    Folding machine heidelberg stahl ft 36j.
     
  4. pakerpakiu

    pakerpakiu New Member

    Joined:
    Apr 2021
    Messages:
    4
    Location:
    malaysia
    This suction valve not function .
     

    Attached Files:

  5. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    ok, procedure with my steps, since the power supply control the valve solenoid for Feeder, see if there are some fuse, as i did indicate
     
  6. pakerpakiu

    pakerpakiu New Member

    Joined:
    Apr 2021
    Messages:
    4
    Location:
    malaysia
    Already check all the fuse is ok .
     
  7. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    O,K
    But you do not follow my steps;

    in any case you must measure the
    1) secondary of main transformer for Vac,

    2) and then test the Fuses,

    3) and see the output from Vdc, from the BRIDGE RECTIFIER.!!!

    4) power supply control the valve solenoid for Feeder

    Let me know, sincerely

    Blessing

     
  8. satq

    satq Member

    Joined:
    Jun 2019
    Messages:
    23
    Location:
    sanaa,yemen
    hi ...i have problem with folding machine .it is not run ..when i switch on appear error
    please help me
     

    Attached Files:


  9. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Hi sir;

    Is a good idea,1) Reset the circuit breaker to the input of machine, clean it for corroded etc, tight wires, and see if the voltages in the input and out put of the c. breaker is there, or FUSES.

    2) Test the if the machine has transformer, measure the primary and secondary with the DMM, According with the Schematic diagrams , look for corroded wires, loose wires, or cut wires. Tigh very well connector, and clean it.

     
Loading...