Cd 102 move 10 degree in inching and stops and machine is not running

Discussion in 'Heidelberg Printing Presses' started by Rahul7011, Feb 11, 2021.

  1. Rahul7011

    Rahul7011 Member

    Joined:
    Dec 2018
    Messages:
    7
    Location:
    Delhi
    Can anyone help me in this problem with (Heidelberg cd 102 6+L) machine is inching 10 degree and stops when we again press the inching switch it will moves 10 degree again and stop.and not running machine,there is no lock showing in cptronic,no error in any card
     
  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Hi sir;

    Please test the module SLT for Drive Main Motor , specially;

    a) SBM1
    B)SBM2
    Both module are Power rectifier , responsible, for backward, forward inching, Run the press, for the winding of Armature, and field circuit of main motor

    Can be open, or short circuit, or Leak, and by that reason the machine will STOP and NOT run.

    C)Clean very well the module from Oxide, and Retight the wire, Examine the rest of electronic components

    D) Test the input Voltage of Vac, must be in 10% up or down. NOT more.

    Blessing
     
  3. Rahul7011

    Rahul7011 Member

    Joined:
    Dec 2018
    Messages:
    7
    Location:
    Delhi
    But it is not giving warning bell sound when i press the running switch.but while inching its giving warning bell sound
     
  4. junker1984

    junker1984 Senior Member

    Joined:
    Jan 2010
    Messages:
    1,031
    Location:
    US, Midwest
    Yes, Chock gave you steps to follow. Unless you’re waiting on an easier fix, which is unlikely, suggest you follow his directions. You may wish to also check physical brake (the one on main motor).
     

  5. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Hi sir;

    Please do my steps very carefully, otherwise, you will take around the same problem.

    Blessing
     
Loading...