Error 6233 on Horizon BQ -470 perfect binder

i have an error on Horizon BQ-470 perfect binding machine , In manual it states that i should check circuit breaker if its tripped but its not what else can cause that error 6233 ,
anyone with an assistance?

 

Hi sir:

The indication for the error 6233 is the circuit breaker Q10 is tripped,to due the three phase power supply to the Servo Amplifier A10 is defective, this c.breaker control the
M10: Clamp Rotating Motor.

1) Test: a) connection between Q10 vs A10 Servo Amplifier for M10, for loose wires, or contacts burns, or defective , or dirty, or corroded.

 

Okey I will try the test u have mentioned

 

Ok sir Fine.
Let me know.

 

I have tested phase voltage on servo amplifier on input which is L1,L2 and L3 and the voltage is balancing {200v between phases} but still error 6233 exists

 

Sir you must
Measure the output for Q10 : l1 + l2+ l3 in order to test is oke the Q10 or NOT tripped, if there are 3 phase the Q10 is o.k otherwise if faulty, or dirty, or defective.
If there are Output , the input for A10 amplifier servo, can be faulty, is the reason for the Error Message 6233 is Appearing.
If you are Not expert in issues electrical/electronic, contact some tech electronic or some good Electrical/electronic tech or Engineer.

 

Thank u Sir for ur assistance we managed to buy new amplifier replacing with the defective one and everything is ok

 

ok, sir

Thank you in advance.

Blessing