Collator System DC-8000s

Hello everyone,

this is my first post, so i want to say hello. I'm from Poland.

I have two Collator DC-8000s, but one does'n work. I'm looking for service manual and schemat.

Please help me.

 

What is the fault? I work on a lot of these.

 

error code on Duplo collator

What is a E-3-1 error code on a DC10000s? Does anyone know who to set up a new inverter?

 

Hi sir:
E-1:
This is displayed when the index pulse used for the
paper feed timing can Not be checked by main board.
1) Is the driving belt loose?
2)
When the power is turned off and then
turned on again 4 to 5 seconds later,
and the JOG key pressed, does the motor rotate?

 

Hola Chock
Yo tengo el mismo problema del error E-3-1 en una Collator System DC-8000s, y sobre los puntos que sugiere
1) no tengo ninguna banda suelta
2) al presionar jog no gira el motor y aparece el error quisiera que por favor me ayudar con este problema

Saludos!!!

 

Hi sir;

1) Check the driving belt., for loose, for damage , or lack of tension, minimun 1/8" of deflection

2) If it does, check if the index sensor or index plate is dirty with paper bits, etc.
• Check if the index plate is in the groove of the sensor properly.
• If normal, the sensor or main board is faulty

 

Ok CHOCK I will review those details, abusing your trust believe that you can share the maintenance manual for this equipment with me, I only have operation and parts

 

I already checked what you told me and it keeps marking the same error; right when I also press the BIN button it marks the same error.
We think it could be the motor driver that is damaged. What do you think?

 

Try to test the Motor directly, see the ID plate of Motor, for to apply the correct voltage.

However did you test the index sensor +index plate ????, by loose wires, dirty, lack of voltage or defective???

See what happens