Schneider Senator 76 SC

The machine has been moved to our new location but now on start up the back gauge has reset and is way out of calibration. Does anyone know how to reset calibration?

The screen is showing 3333.33 on desired location but 0 on actual. When I enter a desired measurement the back gauge moves to a random measurement after pressing enter.

I am sure I remember this happening once and we needed to input a code to set calibration but this way a while back and we have since lost the code and don't know how to enter it either way.

Many thanks
Dale

 

I have the same problem can any one help me please

 

Hi
Please
1) see if are all connector very well.
2) look for loose and break wires.
3) look if code 56 is good.

 

Dear Ray
I think you have to put the backguege behind the refranc point and run the backguage foward until the refrance point
regards
Adnan

 

good day sir
What’s code 56 and how to set it
My problem is that i have 2 mm difference between the display and the real cut

 

look for Edge connector board contamined, Clean it.
Most of the electronic board problem, is there!!

 

Thank you for your reply but the problem is in the reference point i need the code of reference point correction because it displays 555.55 but in fact the cut is 2 mm less
Best regards

 

look if code 56 is good

 

Hello
I press ?56? Then it must display 555.55
Can I change it to 553.55
Regards

 

yes you can sir.
But follow the instruction in his operator manual.

 

Ok thanks i will try and tell you what happens
Thanks

 

OK Sir
let me know