Roland 300 Four Color: main drive QuickStop: safety shutdown

Discussion in 'Man Roland Printing Presses' started by adnan azzam, Jun 13, 2018.

  1. adnan azzam

    adnan azzam Member

    Joined:
    Jun 2018
    Messages:
    19
    Location:
    Damascus
    Hi every one
    pls I need help for error messag at starting of the machine got on console and the machine does not run
    main drive QUICKSTOP: sefety shutdown. trouble
    pls advice
    best regards
    adnan azzam
     
  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Hi sir
    What error message do you have at starting machine On console?
    However you must measure the -24Vdc at the Input main switch cabinet+AX(audio frequency generator)
    This Voltage is for the Hardware control main drive , must be in the Tolerance +- o.5%
     
  3. adnan azzam

    adnan azzam Member

    Joined:
    Jun 2018
    Messages:
    19
    Location:
    Damascus
    Hi Mr CHOCK
    thanks for yuor replay
    the message at the start up comes on console is
    UWR Main drive .QUICKSTOP . Sefty shutdown. trouble
    as mentioned up
    I cheched the -24v at
    A344 and A566 it was 24v
    but I found the relay K5-A566 and K2-A566 not working they are off
    Best regards
    Adnan
     
    Last edited: Jun 15, 2018
  4. adnan azzam

    adnan azzam Member

    Joined:
    Jun 2018
    Messages:
    19
    Location:
    Damascus
    Hi Mr CHOCK
    thanks for yuor replay
    the message at the start up comes on console is
    UWR Main drive .QUICKSTOP . Sefty shutdown. trouble
    as mentioned up
    I cheched the -24v at
    A344 and A566 it was 24v
    but I found the relay K5-A566 and K2-A566 not working they are off
    Best regards
    Adnan
     
    Last edited: Jun 15, 2018
  5. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Hi sir
    Good day.
    Please see very well if the coils for K5+K2 'A566 to the coil of the contactors are there -24Vdc????
    I did indicated you the fact the -24Vdc would be present, BUT is there in Tolerance Sir ?
    In other words, if the -24Vdc hast -24.5 is Faulty, or if there are -23.6 is faulty, You must repair the Power supply.
     
  6. adnan azzam

    adnan azzam Member

    Joined:
    Jun 2018
    Messages:
    19
    Location:
    Damascus
    dear Sir
    thanks for help it was problem at A358/11 PCB
    Regards
    Adnan Azzan
     

  7. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    ok Great.
     
Loading...