Ryobi E-P-508 Error

Discussion in 'Ryobi Printing Presses' started by Sano, Jun 13, 2018.

  1. Sano

    Sano New Member

    Joined:
    Jun 2018
    Messages:
    2
    Location:
    Uzbekistan, Tashkent
    The 0 point for doing RPC cannot be detected.
    How to fix this error in Ryobi 750w machine.
     
  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Hi sir
    Hope you are well
    i recommend you Reset the CPU board,normally they have small Switch, in the same board.
    If does Not have , in the CPU Processor diagrams has small Pin called Reset, use small wired connected to ground and touch the Reset pin and the other side and ground.Attached is there some example.
    However you must see if there are ANY leakage in the Pneumatic system for Full RPC , test the Valve bar system if there are Voltage in terminal, and loose any Wires, Hoses, or clamp, or Spring defective..
    Test if there are some part(s) with lack of Lube
     

    Attached Files:

  3. Sano

    Sano New Member

    Joined:
    Jun 2018
    Messages:
    2
    Location:
    Uzbekistan, Tashkent
    Hello Mr.

    Thank you for taking the time for us. I am very glad your answer.
    But we can't find "Reset" switch in the CPU Board. I will send you boards photo. Please mark the where "Reset" switch.

    With best regards.
     

    Attached Files:

    • 1.jpg
      1.jpg
      File size:
      158.8 KB
      Views:
      543
    • 2.jpg
      2.jpg
      File size:
      165.5 KB
      Views:
      515
    • 3.jpg
      3.jpg
      File size:
      227.9 KB
      Views:
      518
    • 4.jpg
      4.jpg
      File size:
      229.6 KB
      Views:
      523
    • 5.jpg
      5.jpg
      File size:
      204.2 KB
      Views:
      524
    • 6.jpg
      6.jpg
      File size:
      211.5 KB
      Views:
      458
    • 7.jpg
      7.jpg
      File size:
      215.2 KB
      Views:
      506
    • 8.jpg
      8.jpg
      File size:
      212.5 KB
      Views:
      542
    • 9.jpg
      9.jpg
      File size:
      216 KB
      Views:
      548
    • 10.jpg
      10.jpg
      File size:
      223.1 KB
      Views:
      496

  4. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Dear Sir
    I do not see any Small switch, and battery backup.
    As i did explain I do not see the CPU(central processor Unit) Ic too, Are you sure this
    this the only Electronic boards?
    Attached example how you will see the CPU board coming in RYOBI, battery, CPU, RAM, ROM small POT for adjust or reset the CPU
    Did you do the steps in search for Leakage in the system RPC ??
     

    Attached Files:

Loading...